JB-818 Latch
The JB-818 brass latch is mortised into the lid and front of a box or case up to the edge of the cove molding. The sprin…
AU $69.52
(beta)
The LI intermediate knife hinge fills the gap in our knife hinge line. This hinge is designed to be installed in the midsection of larger doors to provide additional strength and support. When installed inline with our L-97 knife hinges you receive the added benefit of an extra pivot point with the same low profile look of a knife hinge. This hinge comes with the same unlacquered brass finish as other Brusso products and is manufactured to the same precision standards our customers have come to expect.
This product is available in a Right Handed and Left Handed configuration. Right Handed configuration is shown.
The JB-818 brass latch is mortised into the lid and front of a box or case up to the edge of the cove molding. The sprin…
The RCC-1 Guide Bushing Alignment Tool works to center routers for use with our TJ line of templates. The tool wil…
The L-97 offset pivot hinge is employed when a minimum of visible hardware is desired or when the door must swing free o…
The HD-638 brass quadrant hinge is engineered with a built-in stop that allows a lid to remain open at 95°. The arc …
Similar to our SR-638 Side Rail Hinge, this brass radial knuckled full mortise side rail hinge is engineered with no bui…
The HD-680 brass quadrant hinge is engineered with a built-in stop that allows a lid to remain open at 95°. The arc …
The brass square knuckled full mortise side rail hinge is engineered with a built-in stop that allows a lid to remain op…
The DL-302 is drop leaf hinge designed to be installed on the underside of a table top for desk and table projects that …
The brass square knuckled full mortise side rail hinge is engineered with a built-in stop that allows a lid to remain op…
The L-23 brass offset pivot hinge is employed when a minimum of visible hardware is desired or when the door must swing …
The L-97 offset pivot hinge is employed when a minimum of visible hardware is desired or when the door must swing free o…
The L-97S stainless-steel offset pivot hinge is employed when a minimum of visible hardware is desired or when the door …
The LH-201 brass heavyweight lift-off cabinet butt hinge with two knuckles is used for doors with thicknesses between 3/…
The ST-97 brass center pivot cabinet hinge is employed when a minimum of visible hardware is desired or when the door mu…
The ST-97S stainless steel center pivot cabinet hinge is employed when a minimum of visible hardware is desired or when …